Filter
Top Products
Removing a GBIC 33
Procedure steps
CAUTION
GBICs are keyed to prevent incorrect insertion. If the GBIC resists
pressure, do not force it; turn it over, and reinsert it.
Step Action
1 Remove the GBIC from its protective packaging.
2
Grasp the GBIC between your thumb and forefinger.
3
Insert the GBIC into the slot on the front panel of the Gigabit
Ethernet switching module.
4 Remove the dust cover and insert the fiber optic connector.
—End—
Removing a GBIC
Remove a GBIC to replace it or to commission it elsewhere.
Procedure steps
Step Action
1
Disconnect the network fiber cable from the GBIC connector.
2
Attach a dust cover over the fiber optic bore.
3
Depending on your GBIC model, grasp the extraction tabs located
on either side of the GBIC with your thumb and forefinger, or lift the
extractor handle attached to the GBIC.
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, and GBIC Hardware Components
NN46220-301 02.04 Standard
4.2 14 February 2008
Copyright © 2008, Nortel Networks
.