Filter
Top Products
Installation and Reference for the BayStack 60-12T/60-24T 10/100 Ethernet Hubs
1-6
206378-A
MDI/MDI-X Button
The MDI/MDI-X button sets port 1 on the BayStack 60-12T/60-24T 10/100
Ethernet Hub from a normal (MDI-X) port to an uplink (MDI) port. Set the MDI/
MDI-X button to uplink (MDI) mode to connect your BayStack 60-12T/60-24T
10/100 Ethernet Hub to another Ethernet hub or switch using a standard
straight-through Ethernet cable.
Refer to “
Cable Types and MDI/MDI-X Modes” on page 3-3 for details regarding
using straight-through or crossover cables to connect your BayStack 60-12T/
60-24T 10/100 Ethernet Hub to various network devices.
Rear Panel
The rear panel (Figure 1-3) of the BayStack 60-12T/60-24T 10/100 Ethernet Hub
includes a standard AC power cord receptacle.
Figure 1-3. BayStack 60-12T/60-24T Rear Panel
Hardware and Environmental Requirements
The following environmental and hardware specifications are required for proper
installation and function of your hub:
• Power - 100 to 240 V AC (+/- 10 %), 50 to 60 Hz (+/- 3 Hz)
• The hub should be located in a cool, dry place, with at least 10 cm (4 inches)
of space in front and behind the hub for ventilation.
• Do not place the hub in direct sunlight. Keep the hub away from heat sources
or areas with high amounts of electromagnetic interference.
• If you intend to mount the hub in a rack, make sure you have adequate
mounting screws, brackets, bolts, nuts, and appropriate tools.
• Be sure you have all necessary network cables and connectors.
9259EA