Filter
Top Products
76 Installing Metro Ethernet Routing Switch 8600 modules and connecting equipment
•
Handle fiber-optic equipment with the following precaution.
WARNING
Fiber-optic equipment can emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector
port. Always assume that fiber-optic cables are connected
to a light source.
Navigation
•
"Removing a module" (page 76)
•
"Installing a module" (page 81)
Removing a module
Remove or replace a module in your chassis.
You can remove any Metro Ethernet Routing Switch 8600 module from an
operating switch chassis without turning off the chassis power.
Prerequisites
•
Back up your configuration before you remove a 8691omSF or
8692omSF module.
CAUTION
If the chassis has only one 8691omSF or 8692omSF module
and you remove that module, the switch will not operate.
•
After you remove or replace a module in your chassis, you can expect
the following results:
— If you remove an interface module from an operating switch without
turning off the chassis power and replace it with the same type
module, the system restores the configuration.
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
Copyright © 2005-2007, Nortel Networks
.