Filter
Top Products
Installing the jumper on an ESM 8668 141
P1 connector header, pins 5 and 6
5
Align the jumper contacts with pins 5 and 6 of the P1 connector
header.
6
Slide the jumper onto pins 5 and 6 until the jumper meets the
connector header (see "P1 connector header with jumper installed"
(page 141)).
P1 connector header with jumper installed
7 Replace the ESM 8668 into the chassis (see "Installing and replacing
a module" (page 75)).
8
Enable the slot to activate the ESM 8668 using the CLI command.
Specify the number of the slot where the ESM 8668 is installed for
<slot-number>.
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
Copyright © 2005-2007, Nortel Networks
.