Filter
Top Products
118 Bandwidth Management
The zone must exist before it can be configured for Adaptive Network
Bandwidth Management. See IP Peer Networking Installation and
Commissioning (NN43001-313) for instruction on how to create and
configure basic properties of the zone.
To configure the Adaptive Network Bandwidth Management feature, select a
zone on the Zones web page. See Figure 30 "Zones web" (page 105) and
click Adaptive Network Bandwidth Management and CAC. The Adaptive
Network Bandwidth Management and CAC web page opens, as shown
in Figure 38 "Adaptive Network Bandwidth Management and CAC web
page" (page 118).
ATTENTION
Do not configure Adaptive Networks Bandwidth Management for Zone 0 or Virtual
Trunk zones.
Figure 38
Adaptive Network Bandwidth Management and CAC web page
If the Adaptive Network Bandwidth Management feature is enabled using
the Enable Call Admission Control feature (ZCAC) check box, then the
other parameters can be adjusted as required.
Table 9 "Adaptive Network Bandwidth Management and CAC fields" (page
119) shows the fields in the Adaptive Network Bandwidth Management
and CAC web page, the field definitions, and their LD 117 command
equivalent.
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
Copyright © 2005-2007, Nortel Networks
.