Filter
Top Products
92 Dialing Plan configuration
TYPE RDB
CUST 00
ROUT 120
DES VTRKNODE51
TKTP TIE
VTRK YES
ZONE 101
NODE 51
PCID H323
ISDN YES
MODE ISLD
DCH 12
IFC SL1
INAC YES
To configure the NRS (H.323 Gatekeeper/SIP Redirect Server):
•
Create H.323/SIP endpoints: MO, BO.
•
Create Numbering Plan entries:
— Choose type UDP-LOC.
— Add 504 for endpoint BO.
— Add 501 for endpoint MO.
For information about configuring H.323 Gatekeeper/SIP Redirect Server,
see IP Peer Networking Installation and Commissioning (NN43001-313).
To configure the SRG:
•
Create route and destination code to main office.
•
In the main office screen:
— Set the type of number to ESN LOC.
— The VoIP trunk access code field is empty.
— Set the main office Access Code Length to 1.
You can also include the LOC as the dial out when you configure the
route for the VoIP line pool. This allows users to dial fewer numbers. For
example, if 501 is configured as the dialout, and 6 is the destination
code, the user could dial 6+<main office DN>. Once the system
identifies the route (VoIP trunks) and drops the 6, it adds the LOC in
front of the DN and dials <LOC>+<DN>. In the case of redirected IP
Phones, the BUID is <destination code>+DN. The main office Access
code length, in this circumstance, is set to 1.
•
Dialing plan:
— Set Type to UDP.
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
Copyright © 2005-2007, Nortel Networks
.