Filter
Top Products
NN10364-301 MCS 5100 3.5 Standard 6.0 December 2006
60
Copyright © 2006 Nortel Networks
Procedure 16 Installing CD4
At the management pc,
1 Place CD4 in the CD-ROM drive and press Enter to continue.
WAIT until you see the following statement appear:
”You are now configuring the NTP time source for
this server. The servers which run the
Management and Accounting service will be the
source. You will need to provide the Machine
Logical IP Address of each server. If running
simplex mode, provide the same address twice.”
2 Press Enter to continue.
3 You will see the following message: "NTP Source 1: Enter
the MACHINE Logical IP Address of the Management
Server:
Enter the IP address, for example: 120.120.13.22
4 You will see the following message: "NTP Source 2: Enter
the MACHINE Logical IP Address of the Accounting
Server:
Enter the IP address, for example: 120.120.13.22
5 You will see the following message:
You have chosen to configure NTP as follows:
Type of server: Application
NTP SOURCE (Management IP address):
120.120.13.22
NTP SOURCE (Accounting IP address):
120.120.13.22
Is the above configuration correct (y/n):
Select Y to continue or N to change.
6 Wait until you see the following message:
You are now configuring IPMP (Multipathing)
Please have the Application Servers (Appsvr,
IPCM, WebSvr, WebClientMgr) Physical IP
addresses and the Machine Logical IP address
ready. Have 6 IP addresses that can be used as
ping buddies. Recommendations for ping buddies
are provided.
7 Press Enter to continue.
8 When you see the IP multipathing configuration for Sun Solaris
information appear, press Enter to accept it or type in a preferred
setting. The default failover timeout is set to 1000mSec.