Filter
Top Products
MCS 2-server Sun Fire V100 Solaris Installation and Commissioning Guide
61
Copyright © 2006 Nortel Networks
9 Enter the primary machine physical IP address for the dmfe0
interface: <Physical IP address of the dmfe0
interface>
Example: 120.120.13.23
10 Enter the secondary machine physical IP address for the dmfe1
interface:
<Physical IP address of the dmfe1 interface>.
Example: 120.120.13.24
11 Enter the <machine logical IP addresses of the
servers> that are the ping targets.
Note: Do not enter the IP address of the server you are
working on.
IP Multipathing needs a set of reliable hosts to ping against.
Select a set of three IP addresses in this subnet that belong to
reliable nodes (such as fault tolerant servers). Select the three
nodes from the following list, in order of preference:
For IPMP GROUPS:
• Machine Logical IP address of the database server
• Machine Logical IP address of the Management server
• Machine Logical IP address of the CAM server
• BPS stack IP address
• Other optional devices (PRI Gateway host)
Provide between two and six ping targets or each IPMP group
for proper IPMP failover reliability. Enter the address "0.0.0.0" to
indicate list is complete, if entering less than six targets.
Note: Do NOT use this server's own IP address as a ping
target.
12 Press Enter after each IP address, for example: 0.0.0.0
[Enter] (This is the third ping target machine logical IP
address.).
Example
Enter ping target #1: 120.120.13.22[Enter]
Enter ping target #2: 120.120.13.1[Enter]
Enter ping target #3: 0.0.0.0 [Enter]
Note: 0.0.0.0 ends the ping target list.
13 You will see the configuration summary appear as shown in the
following figure: