Filter
Top Products
46 Microline 320/321 Turbo
|
Forms Tear-Off
!
The status of the Forms Tear-Off menu setting affects
how you set the Top of Form.
To determine the status of the Forms Tear-Off menu
setting, refer to “Using Your Printer, Top of Form,
Forms Tear-Off Status (ON or OFF).”
For information on setting the Top of Form, refer to
“Using Your Printer, Top of Form, Setting Top of Form,
Forms Tear-Off (ON or OFF).”
The Forms Tear-Off feature allows a printed page (continuous
forms, rear or bottom feed, with no pull tractor option
installed) to be torn off without wasting paper or adjusting
the printer.
Forms Tear Off automatically moves the paper from the initial
printing position to the tear-off position, after a time interval
(which you select through the menu).
The top of the page (perforation) is even with the tear bar.
The tear bar is located under the clear top of the access cover.
Paper remains in the tear-off position until the printer
receives more data. Then, the paper moves back down for
printing (retracts to the initial print position).
When printing stops, the paper advances to the tear-off
position.
The default setting for Forms Tear-Off is OFF.
There are two types of Forms Tear-Off.
• Automatic Forms Tear-Off
• Manual Forms Tear-Off
!
If the software package you are using “pauses” while
sending data to the printer, Forms Tear-Off may be
activated (if it is enabled through the Menu). The pause
must be for two or more seconds. No data is lost. Uneven
print registration will occur due to the paper movement.
If the problem occurs, use the menu to turn off this
feature.
!
DO NOT use Forms Tear-Off with labels or multi-part
forms!
!
Forms Tear-Off CANNOT be used when the optional
pull tractor is engaged.