Filter
Top Products
54 Microline 320/321 Turbo
|
Expanded Printhead Gap
Your printer can be used for dedicated bottom-feed printing
on extra-thick multi-part forms. Extra-thick multi-part forms
range from 0.017-inch (0.43 mm) to a maximum of 0.03 inch
(0.79 mm). To print on extra-thick multi-part forms, you
engage the expanded printhead gap feature. This expands the
head gap settings for extra-thick forms and heavy card stock.
It also increases the impact strength of the pins in the
printhead.
!
CAUTION! Once the expanded printhead gap is
engaged, you cannot print on single sheets without
changing the gap back. If you try to print on single
sheets without adjusting the printhead gap, you can
damage the printhead and void your warranty.
To disengage the expanded printhead gap, reverse the
following steps.
To engage the expanded printhead gap:
1 Turn the printer off.
2 Remove the access cover and the pull-up roller assembly.
32T-02.eps and 32T-04UP.eps
QUIETPARKTEAR
FF/LOAD
LF
SEL
SEL
POWER ALARM
MENU
GROUPEXIT
ITEM SET
PRINT
MENU
SHIFT TOF
Micro Feed
Up
Micro Feed
Down
PRINT QUALITY
CHARACTER PITCH
HSD
NLQ
UTL
SSD
10 12 15
17
20 PROP
3 Move the printhead to the center of the platen.
4 Remove the ribbon cartridge.
32T-19_up.eps