70 Microline 320/321 Turbo
|
Explanations of Menu Items
Refer to “Using Your Printer, Menu Mode, Menu Settings Table” for an overview of the menu structure.
7 or 8 Bits Data Word (ML). If your computer system uses
seven bits to make up each unit of data, change this setting to 7.
7 or 8 Bit Graphics (ML). Choose the graphics your system
uses: 7 or 8 dots in each column printed.
Auto CR (IBM). If you want the printer to automatically add
a carriage return when a Line Feed is received at the end of a
line, change the setting to Yes.
Auto LF. If your printout is consistently double spaced,
select No; if it overprints, select Yes.
Auto Feed XT (Epson). If your system uses pin 14 of the
parallel interface to control automatic line feed, change the
setting to Valid.
Auto Select. If you always use the same Top of Form position,
change the setting to Yes.
Bottom Margin. Change to Invalid if you want the printer to
ignore the bottom margin setting. Caution!! This can cause
loss of data and damage the printhead.
Centering Position. Used to limit printhead travel when
printing narrow columns.
Select Mode 1 for the narrow carriage printer.
Select Mode 1 or Mode 2 for the wide carriage printer.
Character Set. Choose Standard (IBM Set I), Line Graphics
(IBM Set II) or Block Graphics.
Code Page. Choose the Code Page character set you wish to
use: USA (IBM 437), Canada French (IBM 863),
Multilingual (IBM 850), Portugal (IBM 860), Norway (IBM
865), BRASC II, or Abicomp.
Draft Mode. Change to SSD if you wish to use the Super
Speed Draft mode of printing. Note: Print Mode must be set
to DRAFT for this setting to be effective.
Emulation Mode. Choose the printer emulation.
ESC SI Pitch. Sets the character pitch used when the ESC SI
command is received.