Filter
Top Products
Microline 1120 User’s Guide
40
Form Tear Off
The Form Tear Off feature allows you to advance continuous forms to the
stacker for tear off.
The printer default for Forms Tear Off is Off. To use this feature, you must
enter the printer menu and turn it on.
Turn On Forms Tear Off
panel.jpg
1. Turn the printer on while holding down the SEL button.
2. Simultaneously press SHIFT and MODE to enter the Function Settings
Menu.
PRINTER CONTROL prints.
3. Press SEL repeatedly until
REAR FEED prints.
4. Press LF/FF repeatedly until FORM TEAR-OFF prints.
5. Press MODE repeatedly until the interval you want to select (2 seconds,
1 second, or 500 milliseconds) prints.
6. Press and hold TEAR, then LOAD/EJECT, then LF/FF. This saves your
setting and exits the menu mode.
Move Continuous Forms Up for Tear Off
Press TEAR to move continuous forms to the tear off position.