Filter
Top Products
E-32 Section 3
Using the Printer's Features
Tear Feature
When you’re using continuous forms with either the
built-in rear-feed tractor or the optional bottom-feed push
tractor, you can use this feature to advance the forms up
to the tear position so you can easily tear off a printed
sheet without wasting paper or readjusting the printer. To
do this, simply press the TEAR button on the front panel.
TEAR
SET
The tear feature can NOT be used when the op-
tional pull tractor is installed!
Forms Tear-off Feature
Never engage Forms Tear-off when printing on
labels!
The Forms Tear-off feature automatically moves the
paper up to the tear position after the selected interval.
When the printer receives data, it will move down to the
initial printing position.
This feature is normally turned off. To activate it:
SEL
SEL
POWER
LF
FF/LOAD
TEAR PARK QUIET
SHIFT
Micro Feed
Down
TOF
Micro Feed
Up
EXIT
GROUP
SET
PRINTITEM
ALARM MENU
MENU
1. Hold the SHIFT button ( ) and press the SEL button
( ) to enter the Menu mode.
2. Press the GROUP button ( ) until the line
Rear Feed Form Tear-Off Off
prints.
3. Press the SET button ( ) until the time interval you
wish to select prints .
4. Hold the SHIFT button ( ) and press the SEL button
( ) to exit the Menu mode and save the setting.
Some programs pause occasionally while sending
data. If the pause lasts more than the selected interval,
the paper will advance to the tear-off position until
more data is received. This extra paper movement can
cause uneven print registration in graphics. If you
have this problem, use the menu to deactivate Forms
Tear-Off.
!
!