Oki 8810n Printer User Manual


 
8
Load Individual Sheets/Forms
1. Pull out the sheet supports (
1
) and move the
sheet guide (
2
) to the right as far as it will go (the
travel of the sheet guide is limited).
2. Place a letter size or larger sheet/form on the
platform anywhere within the “Paper range when
Auto Align is ON” area
The sheet loads in to the print position,
automatically aligning so that it is square with the
print path.
Continuous Forms (“FRONT”)
Set the Printer for Continuous Forms
1. If there is a sheet loaded on the platform, remove
it.
2. With the printer turned on, press SEL to place the
printer off line.
3. Press MODE once or twice until you see
FRONT
on the second line of the display.
The printer changes paths and returns to the on
line state. FRONT appears on the second line of
the display.
Note
To switch back to single sheet feed, follow the
same steps, pressing MODE several times until
you see
MANUAL
on the second line of the
display.
Sheet_G
uide_cro
p.jpg
F5-11a.jpg
Continuous Forms Specifications
•Width
Minimum: 4” (102 mm)
Maximum: 16” (406 mm)
Single Thickness Forms
Weight range: 14 to 34 lb. US Bond
(52.6 to 128 g/m
2
)
Multi-part Forms: Front Feed Tractor
up to 8-part forms (original + 7)
Maximum Thickness: 0.0189” (0.48 mm)
Multi-part Forms: Optional Rear Feed
Tractor
up to 6-part forms (original + 5)
Maximum Thickness: 0.0142” (0.36 mm)
8810_3_Crop.jpg