Filter
Top Products
18 OKIPAGE 8w Lite
Hardware problems
Symptom Problem Solution
Graphic image prints
partly on one page,
partly on the next.
Insufficient printer
memory for this image
at this resolution.
Change the resolution,
reduce the image size,
or install more
memory in your
printer.
When you try to print
nothing happens, but
printer indicates it is
ready to receive data.
Configuration error. Check cable
connection. If more
than one printer is
available, make sure
your printer has been
selected.
Garbage prints. Incorrect cable
configuration. Also,
see Software
Problems.
Check cable
configuration,
continuity, and length.
Odours. Gases are given off by
forms or adhesives
passing through the hot
fusing unit.
Make sure the forms
you use can withstand
heating, and provide
adequate ventilation.
Printer is on but must
warm up before a job
is printed.
Power Save mode is
set on to conserve
energy. The fuser must
heat up before you can
begin printing the next
job.
To eliminate warm up
delay, change Power
Save setting.