Filter
Top Products
132
OKIPOS 425D
|
7.2 About the Validation Printing Area
This section describes the information for the Validation printing area, and it includes notes for using Validation.
1 In Validation mode, you can use the same paper as in Slip mode, but the printing area is not the same as that of Slip mode.
2 Only 1-line printing is supported. When you need to print multiple lines, use the Slip Driver.
3 Use device fonts in the case of Character printing. However, double-high characters are not supported.
4 Test Page Printing at the time of driver installation and Test Page Printing after the installation is done are supported.
5 Double-high device font characters are not supported by Validation.
O425_115.jpg
1 Printing Area
2 Inserting Direction
Symbol Designation Standard Value
W Paper width 70 mm (2.7") or more
A Print starting position 8 mm (0.7") or less
B Left margin 2.54 mm (0.1") or more
C Right margin 2.54 mm (0.1")
D Printing area width Max 160.02 mm(6.3")