Filter
Top Products
Mode Menu 35
Explanations of Menu Items
These explanations are in alphabetical sequence to make it
easier to look them up. Some items only appear when optional
accessories are installed; others appear in several groups in the
menu.
7 or 8 Bit Graphics, Default = 7
Change this setting to 8 if your system uses 8-bit graphics.
7 or 8 Bit Data Word, Default = 8
Change this setting to 7 if your system uses 7-bit data word
lengths.
Auto CR, Default =No
IBM emulation only. If you want the printer to automatically
add a carriage return when a Line Feed is received at the end of
a line, change the setting to Yes.
Auto LF, Default = No
If your printout is consistently double spaced, select No; if it
overprints, select Yes.
Auto Feed XT, Default = Invalid
Epson emulation only. In the Epson emulation, the XT signal
on pin 14 of the parallel interface can control automatic line
feed. Some interface cables are wired in such a way that
automatic line feed is always in effect: this item eliminates this
potential problem. If your system uses pin 14 of the parallel
interface to control automatic line feed, change the setting to
Valid.
Auto Select, Default = No
Determines whether or not your printer will automatically be
selected after you load in paper. With the factory default
engaged, the printer will be deselected so that you can set the
Top of Form. If you always use the same Top of Form position,
change the setting to Yes.
Baud Rate, Default = 9600 bps
Appears only if optional Serial Interface is installed. Set this to
match your system’s transmission speed.
Bi-direction, Default = Enable
Change this setting if you wish to disable bidirectional
transmission (PnP) in Nibble mode.