36 Guide de l’utilisateur Microline 420/421
Bottom Margin, Default = Valid
Change to Invalid if you want the printer to ignore the bottom
margin setting.
CAUTION!!
Setting the Bottom Margin to Invalid can cause loss of data
and damage the printhead by allowing printing without paper.
Busy Line, Default = SSD-
Appears only when the optional Serial Interface is installed. If
Ready/Busy protocol (factory default) is selected, you can
choose which line your system monitors for a busy signal:
• SSD -9V, select SSD-
• SSD +9V, select SSD+
• DTR -9V, select DTR
• RTS -9V, select RTS
Busy Time, Default = 200 ms
Appears only when the optional Serial Interface is installed.
Sets the length of the busy signal when the Ready/Busy
protocol (factory default) is engaged,
Centering Position, Default = DEFAULT
Used to limit printhead travel when printing narrow columns.
• Select Mode 1 for the narrow carriage printer.
• Select Mode 1 or Mode 2 for the wide carriage printer.
Character Set, Default = IBM Set I
Epson and IBM emulations only. Use this to switch character
sets to IBM Set II
Character Set, Default = Standard
MICROLINE emulation only. Use this to switch the character
set to Line Graphics.
Code Page, Default = USA
Choose the Code Page character set you wish to use: USA,
Canada French, Multilingual, Portugal, Norway, BRASCII,
Abicomp, Multilingual 858, or ISO 8859-15.
CSF Bin Select, Default = Bin 1
Appears only when the optional Dual-Bin Cut Sheet Feeder is
installed. Use this to switch to Bin 2 as the default.