Filter
Top Products
Preparation
BASIC OPERATION GUIDE 2-13
Network Settings
IP Address Setting
Use the following procedure to register an IP Address to the machine.
Check with your network administrator before performing this procedure.
The following procedure applies when DHCP is Off and TCP/IP is On.
Refer to Chapter 2, Advanced Operation Guide for details.
NOTE: Any changes made to network settings become valid after you
power the machine off and on again.
1
Press [Printer].
2
Press S or T to select MENU
and press [Enter].
3
Press S or T to select Interface
and press [Enter].
4
Press S or T to select Network
and press [Enter].
5
Press S or T to select TCP/IP
and press [Enter].
6
Press S or T to select Change #
and press [Enter].
GO
CANCEL
Ready
MENU
Back
Print Status Page
Menu
Interface
Back
Parallel
Interface
Network
Back
NetWare
Network Setting
TCP/IP
On
Off
TCP/IP
Change #