Filter
Top Products
Appendix A.1
APPENDIX AAPPENDIX A
APPENDIX AAPPENDIX A
APPENDIX A
DEFAULT PARAMETERSDEFAULT PARAMETERS
DEFAULT PARAMETERSDEFAULT PARAMETERS
DEFAULT PARAMETERS
DEFAULT PARAMETERSDEFAULT PARAMETERS
DEFAULT PARAMETERSDEFAULT PARAMETERS
DEFAULT PARAMETERS
Loading Default Operating ParametersLoading Default Operating Parameters
Loading Default Operating ParametersLoading Default Operating Parameters
Loading Default Operating Parameters
The control parameters can be loaded with
predetermined default values. These are the
settings loaded into the instrument prior to
shipment from the factory. To load the default
values proceed as follows:
a) Press and hold the key and press the
key; the displays will show:
b) Press either the or key; the display will
show:
c) Press the "FUNC" key; the display will show:
This indicates that the loading procedure has
been initiated. After about 3 seconds the loading
procedure is complete and the instrument reverts
to the “Normal Display Mode.” The following is a
list of the default operating parameters loaded
during the procedure:
Default Operating Parameters ListDefault Operating Parameters List
Default Operating Parameters ListDefault Operating Parameters List
Default Operating Parameters List
Parameter Default Value
Alarm Acknowledge OFF
Software Key Unlock
Setpoint Threshold Low range value (if low limit)
High range value (if high or
high/low limit)
Setpoint1 Threshold Low range value
Setpoint Threshold
Hysteresis 0.1%
Alarm Threshold Low range (if process alarm)
100 (if deviation or band
alarm)
Alarm Hysteresis 0.1%
LHL-A-NEUTRO.pmd 19/04/2004, 15.281