Filter
Top Products
50 • Custom Receipts and Labels User Manual and Technical Guide The O'Neil microFlash Series of Printers
Line Printer Mode
Line Printer Mode allows you to create simple receipts and labels which may include
signatures and graphics. The table below details the host commands available when the
printer is in this mode.
Command Description Page
ESC C n Set form length. Range for “n” is 1-255 52
ESC A n Set interline spacing; n = 0 (default) 52
CAN Cancel line buffer 52
ESC V n1 n2 Bit-mapped graphics mode select 53
ESC B Begin acceptance of compressed graphics 54
ESC E End acceptance of compressed graphics 54
SO Set double wide print 54
SI Condensed print 54
FF Form feed 55
LF Line feed 55
CR Carriage return 55
ESC w n Font select. Range for “n” is 21 - 26 hex 55
ESC @ Reset the printer 56
ESC Hn Multiply height “n” times 57
ESC Q n1n2 Advance n1n2 from “Q” mark 57
ESC R n International Font selection 57
ESC ! n Set double wide and double high 57
ESC EZ Go to Easy Print Mode 57
All Line Printer Mode commands are case sensitive. Where you see lower
case letters, use lower case. Where you see upper case letters, use upper case.
The “n”s are binary numbers, not ASCII (see indvidual commands)