Filter
Top Products
Programming Guide 11
LED and Beeper Indicators
The scanner provides a set of indicators that verify/announce the vari-
ous scanner functions.
LED Indicators The Amber “Laser ON” LED (located on top rear of scanner)
- lights whenever laser power is on.
The Green “Good Read” LED (also located on top rear of scanner)
-Flashes
1
once to indicate when a “good read” has occurred.
-Flashes
1
slowly on and off to indicate the scanner is in Pro-
gramming Mode.
The Beeper While in Scanning mode...
- Sounds
1
four times at power-up.
- Sounds
1
once following a “good read.”
- Sounds
1
six rapid “chirps” to indicate an error (error tone).
While in Programming mode...
- Sounds
1
one time when entering/exiting the Programming
Mode.
- Sounds
1
three times to indicate a successfully programmed
feature.
1. The green LED and Beeper are configurable features and may have been modified or disabled at
an earlier programming session. See the section in this manual titled
General Features for
more details.