Filter
Top Products
1892 1335 - Orion Radio Modem Operating Instructions - v1.3 / Aug 2006 25
The current value of most parameters can be found out by adding a question mark to the
end of the code which sets it, for example:
ATB1?<enter>
to which the modem responds
1<CR><LF>
Capital letters MUST be used for all command instructions. A space after AT is optional,
so the commands AT B1? and ATB1? are functionally identical.
Ending Command Mode (ATO)
v Before ending Command Mode, make sure that you save any changes you
wish to keep by issuing the AT&W command.
Command Mode is ended by inputting the string
ATO<enter> (letter O)
The modem responds with
OK<CR><LF>
The modem is now ready for normal data transmission, and if a new baud rate was set, it
now comes into effect.
Commands
Command Description Values Note
<wait>+++<wait>
Start Command Mode
<wait> period set by
ATS154=
ATO
End Command Mode letter 0, not zero