Filter
Top Products
(6) When the new surge protector board has been secured
to the FW-SP-250 cover, reinstall the FW-SP-250 as shown on
pages 10-11.
(3) Remove the FW-SP-250 (secured
by six Phillips screws).
(2) Remove the AC Wiring
Compartment cover (secured by
two Phillips screws).
(1) Remove the DCC or Turbo
cover (secured by four Phillips
screws) and the DC battery caps.
15
FW-SP-R (REPLACEMENT) for the FW-SP-250
In the event an FW-SP-250’s board is damaged, it can be replaced without going to the expense of
replacing the cover as well.
Tools Required to Install: Purpose:
• Slotted screwdriver • Wiring to the AC wiring block
• Phillips screwdriver • Remove and install covers
• 13 mm socket (torque ratchet) • Securing wires to FX DC terminals
Procedure: Be sure all AC and DC power to the FX is shut o before installing the FW-SP-250.
(5) The new FW-SP-R installs
on these four stando s on
the inside of the FW-SP-250
cover; torque to 8-12 inch-
pounds.
(4) Remove
the damaged
FLEXware Surge
Protector by
unfastening
these four
Philips screws.