Filter
Top Products
38
Parts and their functions
(continued)
pw Wireless remote controller
(optional accessory)
1 ON/STANDBY button
Each time this is pressed for 2 seconds, operation
switches between turning on the unit’s power and
establishing the standby status.
p When operation is transferred to the standby mode:
The current pan-tilt position is stored in the memory
(as a POWER ON preset), and the panning/tilting
moves so that the camera points in the backward-
facing direction.
p When operation is transferred to the POWER ON
mode: Panning/tilting moves to the position which
was stored in the memory (as a POWER ON
preset) when operation was transferred to the
standby mode.
Notes
2 Signal transmission window
3 MENU button
Each time this is pressed for 2 seconds, operation
switches between displaying the unit’s camera menu and
exiting the camera menu.
When it is pressed quickly (for less than 2 seconds) while
a menu is displayed, the setting change is canceled.
Furthermore, the pan and tilt movement range limits
(limiters) are set and released by operating the MENU
button, PRESET/LIMIT button and the pan-tilt buttons
([], [], [] and []).
For details, refer to “Setting/releasing the limiters” (pages 102
to 103 in the <Operations and Settings>).
4 CAM1 to CAM4 buttons
These are used to select the units that are to be operated.
Once a button has been selected, the unit corresponding
to the selected button can be operated.
5 SET button
If this button is pressed when one of the “Manual1 to 3”
settings has been selected for “Scene” on the camera
menu and the AWB A memory or AWB B memory has
been selected by the white balance adjustment, the white
balance is automatically adjusted and registered in the
selected memory.
6 MODE button
This is used to select the video signals which are output
from the unit.
Each time it is pressed, the signals are switched between
the color bar signals and camera video signals.
p The setting for the Down CONV. Mode item when
color bars are displayed is fixed at “Squeeze”.
If “SideCut” or “LetterBox” has been selected, the
HDMI output will not appear for a few seconds
when the color bar display is set to ON or OFF.
Note
7 GAIN buttons [OFF] [LOW] [HI] [AUTO]
These are used to set the gain.
The gain increase can be set in three steps using the
[OFF], [LOW] and [HI] buttons.
[LOW] is set to 9 dB, and [HI] is set to 18 dB.
When the [AUTO] button is pressed, the AGC function
is activated, and the gain is adjusted automatically
depending on the light quantity.
The maximum gain of the AGC function can be set using
the camera menu.
8 Preset memory call buttons [1] to [12]
These are used to call the information on the unit’s
directions and other settings, which have been registered
in the unit’s preset memories No.1 to No.12, and
reproduce those settings.
Settings in preset memories No.13 and above cannot be
called from the wireless remote control.