Filter
Top Products
9
Supplying the power
An Anton/Bauer or V-mount type of battery pack or an external DC power supply can be used to power this
monitor.
Using the Anton/Bauer type battery pack
1.
Install the Anton/Bauer type of battery pack.
Battery pack
2.
Insert the battery pack and slide it in the direction
of the arrow.
Release
lever
<Reference>
To remove the battery pack, slide it in the opposite
direction to the one in which it was attached while
keeping the release lever on the battery holder pulled
down all the way.
Using a V-mount type battery pack
CAUTION:
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that
contained in the operating instructions unless you
are qualified to do so.
1.
Remove the battery holder.
Battery holder
2.
Install the accessory battery mount terminal block.
Battery mount terminal
block
3.
Fix the V-mount type battery holder with four screws
(length 8 mm (5/16 inch)) supplied with the holder,
and then fasten the two screws on the terminal
section.
V-mount type
battery holder
This connector
is not used.