Filter
Top Products
11
Getting Started
6 Press [Finish].
7 Input the correct date, time and time zone and press [Close]. You can also complete
these settings at a later time.
8 Setup Windows
Moving the cursor ( ) or clicking buttons can be performed with the touch pad ( page 15).
Windows 98
1 Select settings for your region and your keyboard layout, then press [Next].
(for U.S.A.: United States 101)
2 Enter your name, then press [Next].
3 Select [Skip] at the [Using Your Modem to Connect].
4 Select [Yes] at the [Cancel Dialing], then press [Next].
The License Agreement will be displayed.
5 After reading the agreement, select [I accept this agreement] or [I do not accept the
agreement], then press [Next].
If [I do not accept the agreement] is selected, the Windows setup will be aborted.
<During the setup procedure after reinstalling only>
After accepting the agreement, the [Windows product key] is displayed.
Input the Product Key written down in the "Customer's Record" section, then
press [Next]. ( page 9 step 2 )
NOTE
2 Select [Next].
3 Input your name and organization, then select [Next]. (It is possible to omit the orga-
nization item.)
4 Input your computer name and select [Next].
5 Input an Administrator password and select [Next].
6 Select [Finish].
7 Following the display, press Ctrl + Alt + Del . Input the password set in step
5 and select [OK], then select [Close] at the [Welcome] display.
As the computer starts up, it will be necessary to input the password set in step 5 .
(To next page)
If [I dont accept this Agreement] is selected, the Windows setup will be aborted.
NOTE
CAUTION
Remember this password! If the password is forgotten, Windows NT cannot be
operated.
Windows NT
1 The Software License Agreement will be displayed. After reading the agreement, se-
lect [I accept this Agreement].