Filter
Top Products
6.3.4. Assembly of Touch Pad
The hooks are hooked
The hooks are inserted
Pad Cover
Putting of pad cover
It is confirmed that all
LED lenses fit in the
hole of the pad cover
Pin for positioning
Touch Pad
The touch pad
is put
Putting of Touch Pad
Touch Pad
PAD FFC
Insertion of PAD FFC
PAD FFC is
inserted in the
connector.
(Direction where
the reinforcement
version is seen)
Sets in the dent
PAD sheet
Putting of PAD sheet
This line must
become vertical
After putting of the
PAD sheet, the
Flaking off paper is
peeled off
Pad button
Latch is inserted in the top case(4 places)
Installation of Pad button
Puted in the gasket
ditch
Inserted in the
positioning pin
Putting of PAD cover tape
0.5mm
1mm
1mm
2mm
PAD cover
PAD cover tape
6.3.5. Processing of DC-IN Cable and Coaxial Cable
The cable is processed to
the ditch of the bottom case
The cable is processed with
the boss between ribs
Confirm the terminal is vertical
Coaxial cable
6.3.6. Obtaining of Side Cover (L)
DC Jack Holder
the under hooks is hooked
the bottom case
the under hooks is hooked
the bottom case
Side Cover(L)
The upper part is shut with
lower hooks put on the
bottom case.
39