- 33 -
The unit is put into recording pause approx. 1 second when the unit is turned on with the
mode set to or .
≥ Depending on the recording conditions, start time may be longer than 1 second.
≥ In the quick power on mode, the zoom magnification becomes 1k.
This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is
reopened.
≥
Quick start will not work if there is no SD card inserted.
≥ /
Quick start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
≥ Change the mode to or .
1 Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is
set to or .
The status indicator A flashes green and the unit
goes into quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put
into recording pause.
≥ When in quick start standby mode about 80% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
≥ Depending on the recording conditions and menu settings, time for quick start may be
longer than 0.6 seconds.
≥ It may take some time for automatic white balance to adjust.
≥ In the quick start mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 32) is set to [5 MINUTES] and the unit automatically goes into quick
start standby mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
[QUICK POWER ON]
[OFF]/[ON]
[QUICK START]
[OFF]/[ON]