Filter
Top Products
ENGLISH - 21
Basic Operation
Projecting an image
1. Switch on the connected devices.
Press the play button of the required device.
2. Press the INPUT SELECT button to select the
required input method if needed.See "Input
switching" on page 22.
The image will be projected on the screen.
1. Press ASPECT to select the required aspect
mode. See "ASPECT" on page 32.
2. Adjust the projected image with the Shift
lever. See "Lens shift and positioning" on
page 16.
3. Adjust the angle of the projector.
Screw down the Front leg adjuster and adjust
the angle vertically.
4. Adjust the focus and the projected image
size.
Turn the Focus ring and Zoom ring to adjust
the image.
You can confirm the result with TEST
PATTERN.
Selecting the input signal
NOTE:
AUTO SEARCH is ON as default and the signal from the connected devices is detected automatically. See
"AUTO SEARCH" on page 34.
Positioning the image
NOTE:
Do not touch the Air exhaust port as this may
cause burns or injury.
If keystone distortion occurs, see “KEYSTONE”
on page 33.
Unlock
Zoom ring
Focus ring