Panasonic PT-AE300U Projector User Manual


 
50-ENGLISH ENGLISH-51
Advanced OperationOthers
Indicators
There are two indicators on the control panel of the projector which give
information about the operating condition of the projector. These indicators
illuminate or flash to warn you about problems that have occurred inside the
projector, so if you notice that one of the indicators is on, turn off the power
and check the table below for the cause of the problem.
Problem
Indicator
display
Flashing (red)
(Lamp unit on)
The surrounding
temperature or the
temperature inside
the projector has
become unusually
high.
Illuminated (red)
(Lamp unit on)
The temperature
inside the projector
has become
dangerously high, or
the temperature has
suddenly changed.
BThe ventilation holes may be covered.
BThe ambient temperature in the place of use may be too high.
BThe air filter may be blocked.
BUncover the ventilation holes.
BSet up the projector in a place where the temperature is
between 0 °C (32 °F) and 40 °C (104 °F) and the humidity is
between 20% and 80% (with no condensation). [If you set the
FAN CONTROL to “HIGH” (page 40), set up the projector in a
place where the temperature is between 0 °C (32 °F) and 35 °C
(95 °F) and the humidity is between 20% and 80% (with no
condensation).]
BTurn off the MAIN POWER switch by following the procedure
on page 23, and then clean the air filter (refer to page 53).
Possible
cause
Remedy
The surrounding
temperature or the
temperature inside
the projector has
become dangerously
high, causing the
lamp unit to be
automatically shut
off.
Flashing (red)
(Lamp unit off)
TEMP indicator
Error displays
Errors may be displayed while using an SD memory card. If an error occurs,
check the following table for a description of the error.
Error display Details
NO CARD
BThere is no SD memory card inserted.
UNFORMAT
BThe inserted card does not match the required
specifications, for example the format is different.
DATA ERROR
BThe data is not compatible and cannot be played
back.
WRITE ERROR
BThe data could not be saved onto the card. Check if
the SD memory card is write-protected, or if it has
enough free space available.
ERROR
BIf “ERROR” is displayed instead of a thumbnail
image, it means that the image cannot be displayed
because there is no data or the data is incompatible.
?
BIf “?” is displayed instead of a thumbnail image, it
means that only the thumbnail data cannot be found.
UNEXPECTED
ERROR
BAn error occurred during an operation. If the problem
cannot be reset by pressing the SD MENU button,
turn off the projector’s power while referring to
“Turning off the power” on page 23, and then turn the
power back on again.
READ ERROR
BThe data cannot be read from the card.
NO DATA
BThe SD memory card does not contain any data that
can be played back by the projector.
NOTE:
BPress the SD MENU button to clear an error display.
BA 2-digit error code will be displayed with an error display.
You may need the error code when asking for service.