Filter
Top Products
ENGLISH-47
Adjustments and settings
46-ENGLISH
TV-SYSTEM
(S-VIDEO/VIDEO only)
This should normally be set to
“AUTO”. If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
ADVANCED MENU
Picture settings can be adjusted in
more detail.
Press the ENTER button to display
the “ADVANCED MENU”
GAMMA HIGH/MID/LOW
These items are for adjusting the
gradation of the bright, medium and
dark scenes in the projected image
respectively.
CONTRAST R/G/B
These items are for adjusting the
color temperature of the white areas
of the projected image by changing
each level.
BRIGHT R/G/B
These items are for adjusting the
color temperature of the black areas
of the projected image by changing
each level.
COLOR MANAGEMENT
This item is for adjusting the
selected colors of the projected
image to suit your preference, and
saving the settings. Refer to page
36 for details.
MEMORY SAVE
Press the ENTER button to display
the “MEMORY SAVE” menu.
The settings adjusted in “PICTURE”
menu can be saved. Press the F or
G button to select the number
(“MEMORY 1/2/3”) in which you
want to save the setting, and then
press the ENTER button.
The confirmation screen will then be
displayed. Press the I or H button
to select “OK” and then press the
ENTER button.
The current picture setting will be
saved.
MEMORY LOAD
Press the ENTER button to display
the “MEMORY LOAD” menu.
(If any setting is not saved in the
“MEMORY SAVE” menu, the
“MEMORY LOAD” menu will not be
displayed.)
Refer to page 34 on how to retrieve
the saved settings.
SIGNAL MODE
(PC/YPBPR/HDMI only)
This displays the type of signal
which is currently being projected.
Refer to the list on page 64 for
details on each type of signal.
Projecting sRGB-
compatible pictures
sRGB is an international color
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-
compatible pictures to be
reproduced more faithfully, make
the following settings.
#Select “PICTURE MODE” and
set it to “NATURAL”.
$Press the MENU button or
RETURN button on the remote
control unit to display the sub-
menu for the “PICTURE” menu,
and then press the NORMAL
button on the remote control
unit.
%Select “LAMP POWER” in the
“OPTION” menu and set it to
“HIGH”.
NOTE:
BWhen set to “AUTO”, the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.
NOTE:
BYou can save up to 3 settings
for each of the 2 signal groups
described below (up to 6
settings can be saved).
S-VIDEO, VIDEO, YPBPR,
HDMI (except for VGA480
signals) and 1 125 (1 080)/60i
and 1 125 (1 080)/50i signals
from PCs
VGA480 HDMI signals and PC
[except for 1 125 (1 080)/60i
and 1 125 (1 080)/50i signals]