Filter
Top Products
24
Connection
Before connection, read carefully the instruction
manual for the device to be connected.
Turning off the power switch of the devices
before connecting cables.
If any connection cable is not supplied with the
device, or if no optional cable is available for
connection of the device, prepare a necessary
system connection cable to suit the device.
Video signals containing too much jitter may
cause the images on the screen to randomly
wobble or wafture. In this case, a time base
corrector (TBC) must be connected.
The projector accepts the following signals:
video, S-Video, analog RGB and digital signals
from the PC.
Some PC models cannot be connected to the
projector.
The pin-out and signal names of the S-VIDEO IN
terminal are shown in the diagram below.
The pin-out and signal names of the RGB2 input
terminal are shown in the diagram below.
Outside view
Pin No.
Ground (color signal)
Luminance signal
Color signal
Signal
Ground
(luminance signal)
Outside view
Signal
R/P
R
G/G · SYNC/Y
PB
SDA
HD/SYNC
VD
SCL
Pin No.
Before starting connection
and are not assigned.
~
, and are GND terminals.
and are effective if the PC has the corresponding
functions.