Filter
Top Products
71
A: Floor mount front projection (Front – Floor mount)
D: Ceiling mount rear projection (Rear – Ceiling mount)C: Floor mount rear projection (Rear – Floor mount)
B: Ceiling mount front projection (Front – Ceiling mount)
Select the setting by displaying the on-screen indications using buttons of the remote control or the control panel on
the main unit.
Procedure of setting
OPTION
ID 2
SETTING FRONT-F
LAMP1 RUNTIME 57h
LAMP2 RUNTIME 60h
LAMP SELECT DUAL
LAMP POWER HIGH
LAMP COOLING TIME SHORT
RS232C SETTING
RGB2 SELECT RGB1 OUT
OSD POSITION 1
:MENU SELECT
:CHANGE
MAIN MENU
PICTURE
POSITION
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
:MENU SELECT
ENTER:SUB MENU
Press the “MENU” button.
The MAIN MENU screen will be displayed.
Select “OPTION” with the
buttons.
Press the “ENTER” button.
The OPTION screen will be displayed.
Select “SETTING” with the
buttons and choose a projection
scheme with the buttons.
Each time or button is pressed, the types of
projection scheme, together with its indications, are
toggled through a cycle as follows:
FRONT-F FRONT-C
REAR-C REAR-F
Press the “MENU” button twice.
The on-screen indications disappear and the
normal screen appears again.
Installation Setting
A projection scheme can be chosen depending on the installation of the projector. If the picture is shown upside
down or in reverse, change the projection scheme using the following figures A to D.