Filter
Top Products
44
Registration of input signal data
The input signal data must be registered because it is not registered on shipment of the projector.
• Up to 96 input signals can be registered.
• Registration is performed by supplying the signal that corresponds to the mounted input module.
Note
Registration of new data
When a new signal is supplied, press the MENU button on the remote control or operating section of the main unit,
and a “NEW SIGNAL INPUTS” screen appears.
Press the “MENU” button.
The “NEW SIGNAL INPUT” screen will be
displayed.
Note
Note
NEW SIGNAL INPUTS.
REGISTER?
NAME:
MEMORY NO:
– –
S.S.NO: – – –
INPUT NO
: VIDEO
fH: 15.73kHz
fV: 59.94Hz
FORMAT: NTSC
ENTER:EXECUTE MENU:ESC
RENAME
NAME: MAC16-A1
MEMORY NO
: A1
S.S.NO: – –
INPUT NO:
RGB1
fH: 15.73kHz
fV: 59.94Hz
SYNC. STATE: H(POS)
V(POS)
:
NEXT FIGURE
:
FONT SELECT
ENTER:SET MENU:ESC
Press the ENTER button.
The “RENAME” screen will be displayed.
• The name of input signal, memory No.,
signal selector input No., input terminal,
frequency, synchronization signal and
other data are automatically identified and
displayed.
•
For memory numbers, 12 pages are
available (eight pieces of data can be
registered on each page, from A to L) and
the lowest unused number in the memory
will be shown automatically. If the memory
has no vacancy, use the overwriting
registration procedure described on the
next page. (Refer to page 45)
• The registration name (NAME) will be
automatically shown by the signal name
and memory number.
When using the registration name automatically
shown,
press the ENTER button.
This completes the registration and returns to the
“MAIN MENU” screen.
To change the registration name,
select characters one by one with the
and buttons and press the and
buttons to fix the characters or
numbers (to delete the automatically
shown name, press the STD button)
and press the ENTER button when the
name is changed successfully.
This completes the registration and returns to the
MENU screen.
• If you press the MENU button instead of
the ENTER button, the new name to
which you tried to change will not be
registered but the signal name
automatically shown will be registered.