Panasonic PT-L735NTU Projector User Manual


 
ENGLISH-57
Care and maintenance
+Select the “LAMP RUN TIME”
by pressing the F or G
buttons.
,Press and hold the ENTER
button for approximately 3
seconds.
The LAMP TIME RESET will be
displayed.
-Select “OK” by pressing the
II
or
HH
buttons and press the
ENTER button.
.Turn off the power.
This will reset the cumulative
usage time for the lamp unit to
zero.
Refer to page 25 for details on
how to turn off the power.
'Install the lamp unit cover, and
then use a Phillips screwdriver
to securely tighten the lamp
unit cover fixing screws.
(Insert the power cord plug into
the wall outlet and then press
the MAIN POWER switch.
)Press the POWER button so
that a picture is projected onto
the screen.
*Press the MENU button to
display the MENU screen, and
select “OPTION” by pressing
the
II
or
HH
buttons.
OPTION
OSD
AUTO SEARCH
AUTO SIGNAL
AUTO KEYSTONE
RGB2 SELECT
RGB/YP
B
PR
VGA60/525P
BLACKBORD
BACK COLOR
NEXT PAGE @
OFF
OFF
OFF
OFF
INPUT
RGB
VGA60
OFF
BLUE
ON
ON
ON
ON
OUTPUT
YP
B
PR
525P
ON
BLACK
SELECT:[^][@]
ADJUST:[{][}] ESC:[MENU]
1820 H
OPTION
PREVIOUS PAGE ^
FRONT/REAR
DESK/CEILING
FAN CONTROL
LAMP POWER
LAMP RUN TIME
FUNC1
CONTROL KEY
AUTO POWER OFF
FRONT
DESK
STANDARD
LOW
MUTE
OFF
REAR
CEILING
HIGH
HIGH
KEYSTONE
ON
SELECT:[^][@] ENTER:[ENTER]
ESC:[MENU]
DISABLE
Power OFF
OK CANCEL
LAMP TIME RESET
NOTE:
B
Be sure to install the lamp unit
and the lamp unit cover securely.
If they are not securely installed,
it may cause the protection
circuit to operate so that the
power cannot be turned on.
NOTE:
B
If the POWER indicator on the
projector does not illuminate red
when the MAIN POWER switch
is turned on, turn the MAIN
POWER switch off again, unplug
the power cord from the electrical
outlet, and check that the lamp
unit and the lamp unit cover are
securely installed. Then turn the
MAIN POWER switch back on.
NOTE:
BIf CANCEL is selected in step
-, the operation for resetting
the lamp time will be cancelled.