Filter
Top Products
ENGLISH-45
Adjustments and settings
44-ENGLISH
Adjusting the position
Press the F or G button to select
an item, and then press the I or H
button to change the setting.
For items with bar scales, press the
ENTER button or the I or H button
to display the adjustment screen,
and then Press the I or H button
to make the adjustment.
When an S-VIDEO/VIDEO/SCART/
HDMI signal is being input
When a YP
B
P
R
signal is being input
When a PC signal is being input
Horizontal position
(H-POSITION)
To move the picture to the left: I button
To move the picture to the right: H button
Vertical position
(V-POSITION)
To move the picture down:I button
To move the picture up: H button
DOT CLOCK
(PC only)
Periodic striped pattern interference
(noise) may occur when a striped
pattern such as the one below is
projected. If this happens, press the
I or H button to adjust so that any
such noise is minimised.
CLOCK PHASE
(PC/YPBPR only)
Adjust the “DOT CLOCK” setting first
before carrying out this adjustment.
Press the I or H button to adjust
so that the noise level is least
noticeable.
POSITION
H-POSITION 0
V-POSITION 0
DOT CLOCK 0
CLOCK PHASE 0
ASPECT 4:3
AUTO SETUP
SELECT ENTER ESC
When the input signal is from a
PC, first select “AUTO SETUP”
and then press the ENTER button
to initiate automatic positioning.
If the optimum setting is not
obtained when “AUTO SETUP” is
carried out, adjust by the following
procedure.
ASPECT
Refer to page 30.
AUTO SETUP
(PC only)
“H-POSITION”, “V-POSITION”,
“DOT CLOCK” and “CLOCK
PHASE” are automatically adjusted
according to the input signal.
Changing the display language
Indicates the language which is
currently set
#Select “LANGUAGE” from the “MAIN MENU” and then press the
ENTER button.
$Press the F or G button to select a language and then press the
ENTER button.
LANGUAGE ENGLISH
ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL
ITALIANO
SELECT ENTER ESC
Turning off the picture momentarily
(SHUTTER)
The “SHUTTER” function can be used to momentarily turn off the picture
when the projector is not being used for short periods of time. The projector
uses less power in “SHUTTER” mode than it does in normal projection
mode.
#Select “SHUTTER” from the “MAIN MENU” and then press the
ENTER button.
$Press any button on either the projector or remote control unit
(except the LIGHT button) to return to normal operating mode.
NOTE:
BWhen the “ASPECT” is set to
“V SCROLL” (page 30), “AUTO
SETUP” cannot be performed.
NOTE:
B
If signals with a dot clock
frequency of 100 MHz or higher
are being input, interference
may not be completely
eliminated when the “DOT
CLOCK” and “CLOCK PHASE”
adjustments are carried out.
POSITION
H-POSITION 0
V-POSITION 0
ASPECT 16:9
SELECT ENTER ESC
POSITION
H-POSITION 0
V-POSITION 0
CLOCK PHASE 0
ASPECT 4:3
SELECT ENTER ESC
BWhen YPBPR signals are being
input, “CLOCK PHASE” can be
adjusted only when
1 125 (1 080)/60i, 1 125
(1 080)/50i, 750 (720)/60p or 750
(720)/50p signals are being input
.