Filter
Top Products
Care and maintenance
ENGLISH-5352-ENGLISH
,Press and hold the ENTER
button for approximately 3
seconds.
The “LAMP RUNTIME” will
change to “TIME RESET
[POWER OFF]”.
BIf the MENU button is pressed,
the lamp time resetting screen
will be cancelled.
-Turn off the power.
This will reset the cumulative
usage time for the lamp unit to
zero.
Refer to page 26 for details on
how to turn off the power.
'Install the lamp unit cover, and
then use a Phillips screwdriver
to securely tighten the lamp
unit cover fixing screws.
(Insert the mains plug into the
mains socket and then press
the MAIN POWER switch.
)Press the POWER button so
that a picture is projected onto
the screen.
*Press the MENU button to
display the “MAIN MENU”, and
then press the F or G button
to select “OPTION”.
+Press the ENTER button to
display the “OPTION” menu,
and then press the F or G
button to select “LAMP
RUNTIME”.
MENU
KEYSTONE
PICTURE
POSITION
SHUTTER
LANGUAGE
OPTION
SELECT ENTER EXIT
OPTION
OSD ON
NR ON
CINEMA REALITY ON
BACK COLOUR BLUE
WSS ON
FRONT/REAR FRONT
DESK/CEILING DESK
FAN CONTROL NORMAL
LAMP POWER HIGH
LAMP RUNTIME 2720H
SELECT ESC
OPTION
OSD ON
NR ON
CINEMA REALITY ON
BACK COLOUR BLUE
WSS ON
FRONT/REAR FRONT
DESK/CEILING DESK
FAN CONTROL NORMAL
LAMP POWER HIGH
TIME RESET [POWER OFF]
SELECT ESC
NOTE:
BBe sure to install the lamp unit
and the lamp unit cover
securely. If they are not
securely installed, it may cause
the protection circuit to operate
so that the power cannot be
turned on.
Lamp unit replacement procedure
#Turn off the MAIN POWER
switch according to the
procedure given in “Turning off
the power” on page 26, and
then disconnect the mains plug
from the mains socket and
check that the area around the
lamp unit has cooled down.
$Use a Phillips screwdriver to
turn the lamp unit cover fixing
screws at the bottom of the
projector, and then remove the
lamp unit cover.
%Use a Phillips screwdriver to
loosen the two lamp unit fixing
screws until the screws turn
freely. Then hold the handle of
the lamp unit and gently pull it
out from the projector.
&Insert the new lamp unit while
making sure that the direction
of insertion is correct, and then
use a Phillips screwdriver to
securely tighten the lamp unit
fixing screws.
When inserting the new lamp
unit, be sure to push it in at the
point A and B .
LAMP indicatorOn-screen display
Illuminates red during
image projection and
standby mode.
Displayed for 30
seconds. Pressing any
button will clear the
display.
More than 2 700 hours*
Remains displayed until
any button is pressed.
More than 3 000 hours*
NOTE:
B
If the lamp usage time has passed 3 000 hours (when “LAMP POWER” has been
set to “HIGH” and when “DYNAMIC IRIS” has been set to “ON”), the projector will
switch to standby mode after approximately 30 minutes of operation. The steps
)
to
-
on the next page should thus be completed within 30 minutes.
Lamp unit cover
Lamp unit cover fixing screws
Handle
Lamp unit fixing screws
A
B
*
These periods of time may become shorter according to the settings of the projector.