Filter
Top Products
ENGLISH-15
Preparation
14-ENGLISH
*)( '
#%&$
)
(
&
*
.
/
'
-
2
1
+
0
,
Projector control panel
Remote control unit
#Power indicator (pages 24, 26 and 27)
This indicator illuminates red when the main power is switched on (standby
mode), and it illuminates green when a picture starts to be projected.
$LAMP indicator (page 49)
This indicator illuminates when it is time to replace the lamp unit. It flashes
if a circuit abnormality is detected.
%TEMP indicator (page 48)
This indicator illuminates if an abnormally high temperature is detected
inside the projector. If the temperature rises above a certain level, the
power supply will be turned off automatically and the indicator will flash.
&Arrow (
FF
,
GG
,
II
and
HH
) buttons (page 38)
These buttons are used to select and adjust items in the on-screen menus.
'ENTER button (page 38)
This button is used to accept and to activate items selected in the
on-screen menus.
(MENU button (page 36)
This button is used to display the “MAIN MENU”. When a menu screen is being
displayed, it can be used to return to a previous screen or to clear the screen.
)INPUT select buttons (page 25)
These buttons are used to switch the input signals from the connected equipment.
*POWER button (pages 24 and 26)
+LIGHT button (page 29)
This button is used to illuminate the buttons on the remote control unit.
,KEYSTONE button (page 28)
This button is used to correct keystone distortion of the projected image
when the projector position is tilted upward or downward.
-FREEZE button (page 28)
This button is used to momentarily freeze projection so that a still picture is
displayed.
.PICTURE MODE button (page 29)
Pressing this button will change the picture mode.
/USER MEMORY button (page 35)
This button is used to display the “MEMORY LOAD” menu.
0COLOR MANAGEMENT button (page 32)
This button is used to display the “COLOUR MNGMT” menu.
1ASPECT button (page 30)
This button is used for aspect adjustment (vertical and horizontal
proportions).
2NORMAL button (page 39)
This button is used to reset the projector adjustment values to the factory
default settings.