Filter
Top Products
OPTION Menu
ENGLISH - 35
Settings
When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See “Projection method”
on page 15.
You can select the required duration of time and set the
off timer to turn off the POWER of the projector
automatically. 3 minutes before turn-off, the countdown
of minutes will be displayed in the lower right corner.
Press I H to cycle through the options. See “Switching
off the projector automatically” on page 23.
If you use the projector at high elevations, set the fan
speed to HIGH. Press I H to select HIGH or LOW.
You can adjust the power of the lamp to save on
electricity, prolong the lamp life and reduce the noise.
You can check how long time has been the lamp used.
You can use the 2 different of test pattern to adjust the
focus of the image. The PICTURE MODE is switched to
DYNAMIC temporarily, and return to the last used
setting when return to projection.
1. Press ENTER to display test pattern 1 and adjust
the focus with the Focus ring.
2. Press ENTER to display test pattern 2 and adjust
the focus with the Focus ring again.
3. Press MENU or RETURN to return to the previous
menu, or press repeatedly to return to the screen.
INSTALLATION
FRONT/DESK
Setting on a desk/floor and
projecting from front
FRONT/CEILING
Mounting in the ceiling and
projecting from front
REAR/DESK
Setting on a desk/floor and
projecting from rear
REAR/CEILING
Mounting in the ceiling and
projecting from rear
SLEEP
ALTITUDE
NOTE:
At 1 400 m (4593 ft) above sea level, the setting
must be HIGH.
LAMP POWER
Options Function
NORMAL
When higher luminance is
required such as movies
ECO - MODE
When lower luminance is
sufficient such as in a small room
NOTE:
When no input signal is detected, the function is
disabled.
LAMP RUNTIME
NOTE:
LAMP RUNTIME is a relevant matter for lamp
replacement timing. See “Care and Replacement”
on page 37.
TEST PATTERN
NOTE:
While a test pattern is displayed, the PICTURE
MODE is changed temporarily to DYNAMIC.
When the projector and/or the screen is tilted,
adjust the focus at the center of the image. The
upper and lower edge might be out of focus.
When the image is distorted in keystone, adjust
the KEYSTONE in POSITION menu.