Filter
Top Products
54
Network/Security setting of the projector (cont.)
Select [NEXT] on the IP address setting window to switch to the wireless setting window.
Make the settings related to the wireless connection between the projector and the network.
Wireless settings
SSID
※
: If the mode is [INFRASTRUCTURE
※
], enter the SSID registered at the access point. If the mode is
[AD HOC], enter the same character string as that of SSID set on the computer to be connected.
MODE : Select [AD HOC] or [INFRASTRUCTURE].
AD HOC
※
: Connect projector and computer directly without access point.
INFRASTRUCTURE
※
: Connect through access point.
AUTHENTICATION : Set the user authentication method used by the network to be connected.
OPEN : Select when making a connection using [AD HOC], or when the access point authentication method is
OpenSystem
※
.
SHARED : Select when making a connection using [AD HOC], or when the access point authentication method is
Shared Key
※
.
WPA-PSK
※
: Select when the access point authentication method is WPA-PSK.
WPA2-PSK
※
: Select when the access point authentication method is WPA2-PSK.
ENCRYPTION : Select the encryption method to be used for communication between the projector and the network.
NONE : Select when transmit without encryption. It is selectable only when [AUTHENTICATION] is [OPEN] or
[SHARED].
WEP
※
: Select when ENCRYPTION is WEP.
TKIP
※
: Select when ENCRYPTION is TKIP.
Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].
AES
※
: Select when ENCRYPTION is AES.
Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].
※ “Glossary” (See page 71)
• If you are unable to connect to the wireless LAN through the access point even after performing the steps in “A Projector
settings (See page 24),” contact the manufacturer of the access point.
• IEEE802.1x is not supported.
• If you finished entering settings, press [NEXT].
WIRELESS DETAILED SETUP
NEXT CANCELRETURN
RETURN
SELECT
ENTER
MODE
AUTHENTICATION
ENCRYPTION
CHANNEL
OPEN
AD HOC
1
NONE
SSID
Panasonic Projector
2/3USER1
SSID has to be entered in lower-case alphanumeric letters.