Filter
Top Products
PANDUIT TDP4*HGMTDPH-MAN
Page 2-10
Section 2: Installation
Operator Panel
LCD
DISPLAY PANEL
The
PANDUIT
®
TDP4*H Operator Panel consists of five LED indicators, two momentary contact switches, three
DIP switches, four adjustment potentiometers and one LCD Display. All of these are accessible from the front of
the printer. They are used to set the printer operating parameters and to indicate the status of the printer to the
operator. After you power on the printer, familiarize yourself with the keys and indicators as it will help you
understand the configuration process.
PRINT Potenitometer to adjust print darkness (fine tuning).
OFFSET Potentiometer to adjust amount of back/forward feed for dispenser/cutter/tear-off
position (+/-3.75mm).
PITCH Potentiometer to adjust home position of the label (+/-3.75mm). Affects stop position
of label feed, print position and dispense position.
DISPLAY Potentiometer to adjust the contrast of the LCD display.
POWER LED, illuminated when the power is on.
LABEL LED, Illuminated when the label supply is not detected.
RIBBON LED, illuminated when the ribbon motion sensor does not detect any ribbon motion
(ribbout out condition).
ERROR LED, illuminated when there is a system fault such as an open print head.
Not Used DSW2 DSW3
POWER
LABEL
RIBBON
ERROR
ON LINE
PRINT
LINE FEED
OFFSET
PITCH
DISPLAY