Panduit TDP43H Printer User Manual


 
PANDUIT TDP4*HGMTDPH-MAN
Page 3-12
Section 3: Configuration
The label Pitch is the distance from the leading edge (the edge
that comes out of the printer first) of a label and the leading
edge of the next label. The leading edge position of the label
can be adjusted relative to the print head +/- 49mm in
increments of 1mm. Once the position is set, it can be fine
adjusted +/- 3.75mm using the PITCH potentiometer on the
Adjustment Panel.
1. The cursor will initially be positioned over the Pitch Direction
setting. Use the LINE key to step to the positive (+) or
negative (-) selection. A positive selection moves the leading
edge of the label forward (away from the print head) while a
negative selection moves the leading edge of the label back
into the mechanism.
2. Once the correct direction is selected, pressing the FEED
key will accept the setting and advance the cursor to the
Offset selection.
3. Use the LINE key to step the first digit of the counter to the
desired setting. The display will increment one step each
time the Cursor keys are pressed. The maximum setting is 4.
4. Press the FEED key to accept the setting and advance the
cursor to the second digit. Again use the LINE key to step to
the desired setting. Once it is correct, pressing the FEED
key will step to the next adjustment.
5. You may wish to print a test label after completing the
adjustments to ensure they are correct.
PITCH OFFSET
+00mm
Moved with negative (-)
offset to print on leading
edge of the label
Leading edge of the label
as detected by the sensor
Original (0 offset) first line
print position
Moved with positive (+)
offset to print on trailing
edge of label
ABCDEFG
ABCDEFG
ABCDEFG
Sensor Position