Filter
Top Products
PANDUIT TDP4*H GMTDPH-MAN
Page 2-9
Section 2: Installation
8. If the labels or tags are already loaded, close
the Print Head Assembly by pushing
downward on the green tab until it latches
closed.
9. Run a test print to ensure that the labels
and ribbons were loaded correctly.
CAUTION: If your labels are less than the full width of the print head, the outside edge will eventually wear out a
small portion of the print head, resulting in an area that will not print. special care must be taken if
you plan to use multiple widths of labels, since the damaged portion of the print head caused from
edge wear on a more narrow label may affect the printing on a wider label. We suggest you plan
your print formats carefully to avoid using the area of possible damage on the print head when using
a wider label. The small area of damage will have no effect on printing with the undamaged part of
the print head. Damage from a label edge is physical damage and is unavoidable. It is not covered
by warranty. It is possible to delay such damage by always ensuring that the ribbon used is wider
than the label stock. This will help to protect the print head from label edge damage.
Ribbon
Core
Tape