Filter
Top Products
PANDUIT TDP4*HGMTDPH-MAN
Page 3-26
Section 3: Configuration
This option allows you to print a test label. It is recommended that
you print a test label after you have changed any of the settings in
the Advanced Mode. The test label allows you to verify that you
indeed did make the desired changes. To enter the Test Print Mode,
power the printer on while pressing the FEED key. The printer will
beep. Release the FEED key and the printer will display the
following message on the LCD panel:
1. Use the LINE key to step the cursor to type of test label you
wish to print. The choices are:
CONFIGURATION
BARCODE
HEADCHECK
MEMORY
FACTORY
Note: This screen will not be displayed for the Memory Test Label.
Once you have selected the type of test label to be printed, use the
FEED key to accept the selection and the display advances to the
Test Print Size display. This display allows you to select the label
width.
1. Use the LINE key to select the label width. Each time the LINE
key is pressed, the label size advances 1 cm until it reaches a
maximum width of 26 cm, at which point it will wrap to the
smallest size of 13 cm.
2. Pressing the FEED key accepts the selection and starts printing
test labels continuously.
3. Press the FEED key to stop the printer.
4. To exit the Test Print Mode, power the printer off and then back
on.
TEST PRINT MODE
CONFIGURATION
Displays the firmware during the initialization.
You enter the Default Setting Mode by pressing the LINE and FEED
keys while simultaneously powering the printer on. The printer will
emit one long beep after which the FEED and LINE keys should be
released.
1. Use LINE key to select either the YES or NO.
2. Once the desired setting is selected, pressing the FEED key will
accept the selection and the printer will reset to the original
default conditions.
DEFAULT SETTING MODE
Occasionally it is desirable to reset all printer configuration settings to their original default conditions. This allows
the operator to start reconfiguration of the printer starting from a know set of conditions.
PRESS FEED KEY TO
STOP PRINTING
TEST PRINT SIZE
10 CM
V 05.00.03.00
INITIALIZING
DEFAULT SETTING
YES NO