Filter
Top Products
PANDUIT TDP4*HGMTDPH-MAN
Page 3-14
Section 3: Configuration
Vertical Offset is the distance down from the leading edge (the edge
of the label that comes out of the printer first) to the first vertical
print position. A positive setting moves the label edge out of the
printer while making it negative moves it back into the printer.
Horizontal Offset is distance that the label image is shifted either to
the right or left on the label. The image is shifted to the left (towards
the inside edge of the label) for a positive setting and it is shifted to
the right (towards the outside edge of the label) for a negative
setting. This setting changes the base reference point for all
subsequent label jobs. It’s effect is identical to the <ESC>A3 Base
Reference point command. Since the printer moves the label in
discrete steps equal to the size of the print dot, the units of measure
for Vertical and Horizontal Offset distance is dots. The maximum
values that can be set is dependent up[on the print head resolution.
If you exceed the allowable limit, the printer will not accept the
setting.
1. Use the LINE key to step the counter to the desired setting
The display will increment one step for each time the FEED key
is pressed.
2. Once the setting is correct, pressing the ENTER key will accept
the setting and advance to the next display.
Note:This setting can be overridden by the Base Reference Point
Command.
PRINT OFFSET
V:+0000 H:+0000
The Calendar is a optional feature allowing the date and time to
be set manually using the LCD Display or via the <ESC>WT
Calendar Set command. This screen will not be displayed if the
Calendar Option is not installed. The last setting, set either
manually via software command, received by the printer will be
the value used. The format of the display is YY/MM/DD hh:mm
(Year/Month/Day/hours:minutes).The date format is fixed and cannot
be changed. This display will only appear if the Calendar Option is
installed in the printer.
To enable the Calendar feature, press the LINE key until the cursor
is over the YES. If the Calendar feature is to be disabled, press the
LINE key until the cursor is over the NO selection. When the desired
setting is selected, press the FEED key.
SET CALENDAR
YES NO