Filter
Top Products
C. Traps and MIBs
C-2 November 2003 6300-A2-GB20-10
DSL Router Traps
Table C-1, DSL Router Traps, lists the traps supported by the DSL router. All traps
are defined with a severity of Critical, Major, Minor, Warning, or Normal. By default,
all traps are initially disabled.
Table C-1. DSL Router Traps
Trap Event(Trap #) Severity Description MIB Variable Binding*
authenticationFailure Minor The authenticationFailure trap
signifies an event where access
has been attempted and failed.
There are several conditions that
can cause an Authentication
Failure trap, such as three failed
attempts to login.
hot_sys.mib
(Hotwire System
MIB)
ifIndex (RFC 1573)
cCN(7) Warning The configuration has changed
via the user interface or an
SNMP Manager. The trap is sent
immediately, providing there has
been no CCN trap for
30 minutes. This suppresses the
sending of numerous traps when
multiple changes are made in a
short period of time.
hot_sys.mib
(Hotwire System
MIB)
ifIndex (RFC 1573)
deviceFailure(2) Major An internal device failure has
been detected by the operating
software for the DSL router.
hot_sys.mib
(Hotwire System
MIB)
ifIndex (RFC 1573)
devFailureStatus
(pdn_HealthAndStatus)
devSelfTestFailure(1) Minor A hardware failure of the unit
was detected as part of the unit’s
selftest. This trap is generated
after the unit has completed
initialization.
hot_xdsl.mib
(Hotwire xDSL
interface)
ifIndex (RFC 1573)
devSelfTestResults
(pdn_HealthAndStatus)
diagApplTestStart(2) Normal At least one test has been
started on an interface;
e.g., Ping, TraceRoute.
hot_xdsl.mib
(Hotwire xDSL
interface)
ifIndex (RFC 1573)
applTestID
applTestType
diagApplTestStop(102) Normal This indicates that a test has
completed on an interface.
hot_xdsl.mib
(Hotwire xDSL
interface)
ifIndex (RFC 1573)
applTestId (pdn_diag)
applTestType (pdn_diag)
applTestStatus
linkDown(3) Normal Informational. ifIndex
(RFC 1573)
ifIndex (RFC 1573)
linkUp(4) Normal Informational. ifIndex
(RFC 1213)
ifIndex (RFC 1573)
warmStart Normal The warmStart trap signifies that
the unit has just reinitialized
itself. This trap is sent after the
unit has been reset (either with a
reset command or the result of a
power disruption).
MIB II
(RFC 1213)
ifIndex (RFC 1573)
* All traps have the Super Overloaded ifIndex as a variable-binding (as a minimum).