Filter
Top Products
9
2. Secure the rear card using the supplied metal screws.
3. Slide the front card into the chassis until you feel resistance as the
front card engages the rear card. When that happens,
gently
push
the front card forward until it is fully seated in the card-edge recepta-
cle of the rear card (it should
click
into place).
4. Secure the front card using the captive fasteners.
Note
The Model 1001R14 chassis supports “hot swapping” of cards,
so it is not necessary to power down the rack when you install or
remove a Model 1058 rack card.
Figure 3.
Model 1058 rack cards
5. Connect the line interface between the units (refer to section 3.3,
“Connecting the Twisted-Pair Line Interface” on page 10)
Note
See Figure 3 for the rack card’s panel arrangements.
6. Connect the Ethernet interface (refer to section 3.4, “Connecting the
10/100Base-T Ethernet Interface” on page 11).
POTS/ISDN
1058DRC
1058DVRC
POTS/ISDN
Port
VLINK
RJ-45 interface
VLINK
terminal block
VLINK
RJ-45 interface
VLINK
terminal block
VLINK
VLINK
Ethernet
Ethernet
Port
Ethernet
Port
Ethernet