SGND & FRGND (JB5)
This strap pertains to the DTE interface, which is a 10-position
modular RJ-45 jack. In the connected (closed) position, this strap links
modular pin 5 (Signal Ground) and frame ground. In the open
(disconnected) position, pin 5 is "lifted" from frame ground.
JB5
Position 1&2 = SGND (pin 5) and FRGND Connected
Position 2&3 = SGND (Pin 5) and FRGND Not Connected
DTE Interface Pin 2 (JB6)
This strap configures DTE interface pin 2 for Ready Start (DSR)
operation when placed on pegs 1 & 2. Placing the strap on pegs 2 & 3
is
not a valid option
when using this rear interface card in conjunction
with the Model 1060RC.
JB6
Position 1&2 = Ready Start (DSR) Operation
Position 2&3 = Not a valid option
4.0 INSTALLATION
This section describes the functions of the Model 1000R16 rack
chassis, tells how to install front and rear Model 1060RC cards into the
chassis, and provides diagrams for wiring up the interface connections
correctly.
4.1 THE MODEL 1000R16 RACK CHASSIS
The 1000R16 Rack Chassis (shown in figure 10, below) has
sixteen short range modem card slots, plus its own power supply.
Measuring only 3.5" high, each Model 1060RC is designed to occupy
only 2U in the 19" Model 1000R16. Sturdy front handles allow the
1000R16 to be extracted and transported conveniently.
4.1.1 The Rack Power Supply
The power supply included in the Model 1000R16 rack uses the
same mid-plane architecture as the modem cards. The front card of
the power supply slides in from the front, and the rear card slides in
from the rear. They plug into one another in the middle of the rack.
The front card is then secured by thumb screws and the rear card by
conventional metal screws.
1211
WARNING! There are no user-serviceable parts in the
power supply section of the Model 1060RC Series.
Voltage setting changes and fuse replacement should only
be performed by qualified service personnel. Contact
Patton Electronics Technical support at (301)975-1007 for
more information.
Figure 10: Model 1000R16 Rack Chassis with power supply