Filter
Top Products
Localization 57
SmartLink M-ATA Getting Started Guide 6 • System
Distinctive Ring Settings
The SmartLink M-ATA Distinctive Ring Settings window (see figure 33) enables you to specify up to 8 sets of
distinctive ring cadences.
Figure 33. Distinctive Ring Setting section of Localization window
The following is a sample ring cadence pattern configuration:
Timeval ::= time in milliseconds
Repeatval ::= # of cycles to repeat
Tonename ::= "RING_0" | "RING_1" | "RING_2" | "RING_3" | "RING_4"
| "RING_5" | "RING_6" | "RING_7" | "RING_8" | "RING_9"
Idle ::= "IDLE"
Active ::= "ON" | "OFF"
Inactive ::= Idle "(" Timeval ")"
Active ::= Active "(" Timeval ")"
Sequence ::= Active | Active "," Sequence
Repetition ::= "[" Sequence "]" Repeatval
Repeat ::= "R"
Cycle ::= Sequence | Repetition
Fullsequence ::= Cycle | Cycle "," Fullsequence
Cadence ::= Fullsequence | Fullsequence "," Repeat | Fullsequence
"," Inactive "," Repeat
Ring ::= Cadence
Note The Bellcore standard ring cadence patterns are shown in table 2.
Table 2. Bellcore standard ring cadence patterns
Name Value
RING_0 ON(2000), IDLE(4000), R
RING_1 ON(800), OFF(400), ON(800), IDLE(4000), R
RING_2 ON(400),OFF(200)]2,ON(800),IDLE(4000),R
RING_3 ON(300), OFF(200), ON(1000), OFF(200), ON(300), IDLE(4000), R
RING_4 ON(500)
RING_5